Home  >  Industrial Supplies  >  Machine Oil Purifier

For recycling all kinds of waste oil, 1. with CE/ISO9001/14001, 2.with strictly QC &strictly TECH, 3.safety - details see: https://www.machineto.com/waste-tyre-oil-recycling-to-diesel-plant-withce-iso-10228156

1.With the rapid development of oil refining industry by waste plastics, scrap rubber and waste engine oil,

the fuel oil produced has been widely applied,and penetrated in all the fields of national economy and

peoples daily lives. However, the rapid

development and the increase of employees in the industry also enable the price of raw material to

increase drastically. How to raise the added value of fuel oil on the basis of decreasing the cost of raw

materialThe simplest method is to re-distill (or called rectify) the waste engine oil and raw oil extracted

waste plastics and scrap rubber. The rectified oil is usually faintyellow or faint red liquid with main technical

indexes reach the standards for 0# or -10# diesel, and may replace the 10#diesel in application. Its price

is 1500Yuan/ton higher than that of raw oil. There are two options of the unit to regenerate the

fuel oil: one is large petrochemical refining plant with investment more than 1 billion Yuan; the other is

currently popular earth burner with investment between 50,000-100,000 Yuan. However, the earth burner

has a bad performance in terms of operating efficiency, security and environmental protection. Thus, it is

now an important subject to have less investment and overcome the weakness of an earth burner.

2. The traditional refinery equipment named earth burner in China now adopts horizontal fixed treater. The

technological process is as below: first manually feed the waste engine oil and raw oil extracted from

waste plastics and scrap rubber from the top of split treater, then seal up the feed inlet and heat up

slowly the bottom of treater with coal of fuel; the volume of a split treater usually is 20 stere, plus15 tons

of material, and usually the smelting completes in two weeks. After the smelting is over, stop for 12 hours

to make the treater fully cool down, then open the dregs outlet at the bottom of treater to discharge

dregs, feed material from the feed inlet of treater to continue another cycle of refining.

1. THE DATA BASIC FOR DIATILLATION MACHINE