Home  >  Apparel & Textile Machinery  >  Apparel Machinery  >  Rhinestone Machines

ultrasonic rhinestone machine, 1.1pc support stand, 2.2mm,3mm,4mm,5mm,7mm,5mm hot spot,9mm flat tips, 3.Low price - details see: https://www.machineto.com/ultrasonic-rhinestone-machine-10255132

ultrasonic rhinestone machine

1.Rated Voltage:100-240V

2.Rated Power:12W

3.Multiple plugs are available

4.ultrasonic rhinestone machine wire length:1.4m

5.7 tips as 2mm(6ss),3m(10ss),4mm(16ss),5mm(20ss),7mm(34ss),5mm hot spot,9mm flat tip

6.With a ultrasonic rhinestone machine support stand

How to using ultrasonic rhinestone machine

Choosing the correct size ultrasonic rhinestone machine size for the stone size you working with, the flat tip is used for flat stone that do not fit into round tips. Screw in the correct ultrasonic rhinestone machine tip size while the applicator is cold

1.With a stone facign faceted side up, place the tip over the stone and pick it up . Do not press hard ,the hot fix stone may stick to the surface.

2.Watch the glue till it starts looking wet and shiny , now the stone is ready tobe applied to the surface. It will take about 5 seconds and up, depending on the size of the ultrasonic rhinestone machine rhinestone or stud .

3.Lightly press the ultrasonic rhinestone machine at 90 degrees to the surface ,move theultrasonic rhinestone machine up and aways . In case the stone gets stuck in the tip, use a pairsof tweezers and push downwards through the slit in the tip to get the stone out .

If the stone has not bonded correctly , place the tip over the stone for a couple of seconds to melt the glue again.

Rated Voltage:100-240V	Apply to rhinestone ,studs, peals, strass
Rated Power:12W	Packing situation: dual-blister card
Preheating time: 2 min	Quantity per carton: 50 pcs
Light indicator --ON/OFF	Carton size:54*50*29cm
ultrasonic rhinestone machine stand	Quantity per 20"container: 17000pcs