Standard single channel contious wood drying equipment in new generation

Working principle of wood drying equipment:

1. The equipment is composed by the furnace and the dying kiln.
2. The equipment uses thermal energy by burning to heat the air in the kiln which is inhaled by the blower on the top of the furnace through pipes. And then send the hot air into the kiln .Next ,the circulating fan in the kiln will heat the timber constantly .The steam generating device can provide steam if it is need during the process of drying .
3. There is moisture hole on the top of the kiln because the timber need to moisture during the process of drying

Specification of wood drying equipment:

1. Brief: The High frequency vacuum wood dryer is a fastest way for drying. It has two advantages 1) High frequency heating, more equal, dry faster; 17times faster than wood dust burnt dryer.
2. The drying cycle are mainly 20-30hours.Vacuum condition, dry faster in lowr temperature to eliminate the problem of split.
3. It is more suitable for the large square wood material as well as hard board leaved tree material as well as other rare wood material.
4. As HF heats from inside, so the core of wood will dry first, and then gradually to the outside, then the vacuum pump extract the moisture out from inside thus make the surface of wood is always wet, for some hard wood if the surface is dried quickly,
5. There will be spark on the surface and leave permanent defect on the wood, but HF vacuum condition will totally eliminate the problem.
6. Temperature control:
7. There is temperature sensor which guard on the temperature, user can set different max and min temperature according to different wood, then if the temperature reaches the max limit, the heating stop, but if it falls to the min, the heating will start again.

Technical parameters:

Main pictures: