SPIN FLASH DRYER / PNEUMATIC DRYER

1. Drying Cum Pulverizing in Fraction of Seconds., 2. Continuous Drying with No Air Pollution., 3. Low Fuel & Power Consumption. - details see: https://www.machineto.com/spin-flash-dryer-pneumatic-dryer-10290219
Condition:NewType:Flash Drying EquipmentPlace of Origin:Uttar Pradesh IndiaBrand Name:SINGHASINI
Model Number:Flash Drying with PulverizationVoltage:415Power(W):100000Dimension(L*W*H):30 Ft X 30 Ft X 40 Ft Height
Weight:10000 KgWarranty:12 Months from the Date of DispatchAfter-sales Service Provided:Engineers available to service machinery overseas 
SPIN FLASH DRYER / PNEUMATIC DRYER
contact supplier for SPIN FLASH DRYER / PNEUMATIC DRYER


WHY A FLASH DRYER ?

Tunnel and cupboard dryers are inherently costly to run, occupy a larger floor space, involve higher number of manual labor and yet the drying rate is slow with much lower thermal efficiency. Compared to this, theFLASH DRYERin its simplest form of mechanical design; is merely a Hot Air Conveyor into which solids, if reasonable free flowing, may be dropped. The material then gets dispersed, thus exposing maximum surface to the drying process. This leads to a very rapid drying rate and the time required is in seconds and not in minutes or hours. Due to the short exposure time and rapid evaporation of water, even though high temperature is employed; the material remains at wet bulb temperature (W.B.T.) until all traces of surface moisture is removed. Thus it is possible to employ high inlet temperature, may be up to 700 C, without affecting the quality of the material, which may even, if it is a heat sensitive one.

WHY FLASH DRYING, DISINTEGRATION OR PULVERISATION?

In a drying process, the internal moisture in the particle, reaches the surface by capillary action and from here the moisture is removed. In other words, it is obvious that the smaller the particle, more rapid will be the drying process. Thus during the process of grinding or Pulverising if‘FLASH DRYING’is also conducted, then it will make the over all system very efficient.

During the normal process of Disintegration or Pulverisation if the material contains high degree of moisture content, then the process of grinding may pose problems due to choking, thereby the output will drop down to a considerable low value. The process will improve satisfactorily if“FLASH DRYING”is also conducted along with grinding. Pick up of the moisture by the feed material may be due to the hygroscopic nature of the material, during transit or storage or may be inherently present in the mining stage.

TYPES OF FLASH DRYERS:

Flash Drying System are designed for specific problems and may fall into one of the following categories:

  1. Flash Drying without Disintegration or Pulverisation.
  2. Flash Drying with Disintegration.
  3. Flash Drying with Pulverisation.
SPIN FLASH DRYER / PNEUMATIC DRYER
Packaging Detail:Wooden Boxes Sea Worthy Packing of all delicate Parts and coating with Anti-Rust on Non-Painted Parts.
Delivery Detail:Three Months

Related Product for SPIN FLASH DRYER / PNEUMATIC DRYER