Silica Sand/coal/Wood chips/rice husk rotary dryer

Rotary Dryer is widely used in the field of building materials, metallurgies, chemical industry, cement and so on. It can dry slag,

coal powder, mining powder, clay, sand, limestone and so on. It is made into rotary body, lifting blade, driving device, supporting

device etc. The dryer has advantages of reasonable structure, high efficiency, low energy consumption and convenient for transp

ortation.

We supply the following dryer: wet material rotary dryer, sand dryer, sawdust dryer, coal dryer, coal slime dryer, bentonite dryer,

ore concentrate dryer, wood chip dryer, cassava dryer, gypsum dryer, cow dung dryer.

Rotary dryer

Dryer Machine characteristics :

1. The internal adopts assembled structure which has improved the accuracy of the equipment and it is easy to transport and

install.

2. According to the characteristics of different fertilizers ,we have arranged the second granulation zone reasonably so as to

improve the granulation effect .

3. Adopts assembled hoist board so as to exchange heat fully and lower the energy consumption .

4. Temperature induction monitor ,uniform vibration and airproof setting , which improve performance and productivity efficiently .

Drawing of rotary dryer

Main technical parameters of rotary dryer

Working Theory of Rotary Dryer

The wet material is taken to the hopper by belt conveyor or bucket elevator, and then the material goes into feed opening through feed pipe with the help of feeder. The slope of the feed pipe shall be higher than the material’s dip angle to make the material flowing into the dryer drum. The dryer drum is a rotary drum and there is a slight slope between the drum and the horizontal line. The material is fed through the higher end, and the heat carrier goes from the lower end, which forms an upstream contact with the wet material. During the movement in the drum, the material gets the heating directly or indirectly, and then is dried. Later the dried material is transferred by the belt conveyor or spiral conveyer at the discharging opening. There are lifting boards on the inside wall, which lifts and scatters the material to make the contact surface bigger between the material and the heat carrier. This can promote the drying rate and push the material forward. Heat carrier is usually hot air or flue gas. After go through the dryer, the substances containing in the heat carrier usually need to be collected by cyclone dust collector. If the air dust content need to be reduced further, bag filter or wet dust remover shall be used.

Details of rotary dryer

Packing of rotary dryer

Service:

1) Pre-sale service:

Freely provide project designing, process designing, choosing suitable equipment for you.

2) Medium-sales service:

Accompany you to complete the acceptance of the equipment,draft the construction scheme and detailed process, and complete process of export

3) After-sales service:

We sent engineer to the scene to guide installation, debugging and training operators.

Factory information

For you placing order or sending inquiry, would you please provide some information?

-What kind of material you are going to dry?

-Capacity per hour you need?

-Water content before and after drying you require?

-What kind of fuel for the dryer?

If you want know more, scan below