Home  >  Chemical Process Machinery  >  Chemical Machinery & Equipment  >  Hot Air Furnace

rotary drum drier:, 1.capacity:8~10ton/h, 2.material can be sawdust,slag,clay limestone,chemical, 3.low price, 4.high efficiency - details see: https://www.machineto.com/rotary-drum-drier-sell-hot-in-malaysia-with-3-ton-output-10293422

Rotary Drum Dry

The main internal structureof rotary drier:

In order to increase the material evenly distributed in the rotor parts of the cross section in good contact with the drying medium, in the cylinder body installation raise plates.There are severaltypes of raise plate.

1). Lifting type: For large or easy to bond the material in the tube wall.

2).Four formats type: Suitable for big density, not crisp or not easily scattered materials.The raise plate will be divided into four pane,and were mutually connected fan-shaped workout room, Materials and the contact surface of the hot gas than large of the lifting type, And also can increase of the filling material rate and reduce material landing height and reduce dust quantity loss and so on.

3).Cross-shaped or frame-shaped:applicable to brittle and easy dispersion small pieces of material,make the material can be evenly dispersed in cylinder whole section.

4).Sleeve type:For double entry Heat transfer for the double (or half the diameter heating) rotary drum dryer raise plate.

5).Separate format(fan): For very fine particles and the material prone to flying powder.materials accumulate on grid board when it into,then cylinder rotates, the material is turning and continue contacts with the hot gases, at the same time, the decrease of height landing, reducing the dry material being gas away possibility.

Above all forms of plate can be distributed throughout the cylinder body.In order to make the material quickly and evenly to the lift board,can also install spiral guide stripper plate 1~5 metres at feed-throat,To avoid the wet bonding material accumulation in the tube wall. At the same time due to drying of material can easily be raised and taken away by waste gas, while in discharging end 1 ~ 2m place not install any Yang board. raise plate

Specifications:

Model	HGT-1000 x 10	HGT-1200 x 12	HGT-1500 x 14
Power	4kw	7.5kw	11kw
Capacity	1~3ton/h	5~7ton/h	8~10ton/h
Diameter of feed materials	0-200*240 mm	0-200*240 mm	0-200*240 mm
Working Temperature	stove 300°C	stove 300°C	300°C
Consumption of wood waste	20-30kg/h	20-30 kg/h	40-50 kg/h
Overall size	Φ1m, length 10 m	Φ1.2m,length 15 m	Φ2.2m, length 28 m
Weight	6000kg	10000 kg	18000 kg