Home  >  Farm Machinery  >  Farm Machinery  >  Oil Pressers

Rice bran oil plant, 1. Installation and training included, 2. Fully automated operation, 3. High oil yield - details see: https://www.machineto.com/rice-bran-oil-plant-with-fine-quality-from-manufacturer-10189464

Rice bran oil plant with fine quality from manufacturer

The whole process of intermittent refining

oil inlet--heating up--deacidification--dealkalizing--washing 2-3 times--dry dehydration.

Main equipments:

.Refining pot

.Bleaching pot

.Vertical blade filter machine

.Deodorization pot

Hydration Deguming & Alkali Refining Deacidification Process

Neutralization:

The crude oil is output by the oil feed pump from the oil tank, and next enters the crude oil heat exchanger to recover part of heat after metering and then is heated to the required temperature by the heater.

After that, the oil is mixed with the metered phosphoric acid or citric acid from phosphate tank in the gas mixture (M401), and then enters the conditioning tank (R401) to make the non-hydratable phospholipids in oil change into the hydratable phospholipids. Add the alkali for neutralization, and the alkali quantity and alkali solution concentration depend on the quality of the crude oil.

Through the heater, the neutralized oil is heated to the temperature (90°C) suitable for centrifugal separation to remove the phospholipids, FFA and other impurities in the crude oil.

For the separation, the Sweden Alfa-laval PX80 separator is used, with the production capacity 300t/d. The separated gleditsia sinensis lam can produce acidic oil or be sold, and the oil is goes to the washing process.

Washing:

About 500ppm soap is still in the neutralized oil from the separator. To remove the remaining soap, add into the oil about 5~8% hot water, with water temperature 3~5 °C higher than the oil generally. To achieve more stable washing effect, add phosphoric acid or citric acid when washing. The re-mixed oil and water in the mixer is heated to 90-95°C by the heater, and then enters the wash separator to separate the remaining soap and most water. The water with soap and oil enters into oil separator to separate out oil in the water. Further catch the oil outside, and the waste water is discharged to the sewage treatment station.

Vacuum drying stage:

There is still moisture in the oil from the wash separator, and the moisture will affect the stability of the oil. So the oil at 90°C should be sent to vacuum drier to remove the moisture, and then the dehydrated oil goes to the decoloring process. Finally, pump out the dry oil by canned pump.

Our supply and service:

.Whole set of equipment for production line

.Motor and power control system

.Installation material

.Drawing of process description, equipment layout, foundation and hole, construction

.Drawing of power control

.Staff training and long-term technical service