Home  >  Wood Working Machinery  >  Woodworking Machinery  >  Carbonization Stove

No pullotion wood charcoal carbonization stove, 1.wood carbonization stove, 2.big capacity - details see: https://www.machineto.com/no-pullotion-wood-charcoal-carbonization-stove-10340906

No pullotion wood charcoal carbonization stove

Introduction of carbonization stove

Carbonization furnace is a machine to make charcoal from waste of agriculture and forest, such as rice straw,

ricehusk,sawdust, charcoal kiln utilizes the material in the carbonization process, produce the carbon

monoxide,methane,oxygen and combustible gas recovery and purification, circulation combustion

of advancedtechnology. Which could solve the ordinary coking furnace in the coking process of smoke

pollution totheenvironment problem, and solves the charcoal machine equipment the heat problem,

fully done autonomousself, improve the equipment continuity, economy, make full use of agriculture

and forestry residues, whichmake the reduced the our country forest resources supply and demand

contradiction nervous, greening theenvironment to do more contribution.

How to use the wood carbonization stove

1.There have 4 of steel drums at the top of the machine body. Under each drum, it’s a small room to make fire.

2.The 4 drum have lids on top, and in the middle of the lids, there also connect with 4 pipes, is used for gases to escape (gases will come out when heating the drum). This pipe is called the "retort." Fill the retort with the chunks of hard wood and place the lid on top.

3.Place wood and start the fire at the bottom of the drums. Place the retort inside the drum, resting it on the fire.

4.Wait for the fire to get really hot

5.Keep an eye on the smoke. You should be burning for about three hours and the smoke should be……, which means that the water, tar and other compounds in the hardwood chunks are being released. Keep the temperature up by occasionally adding wood to fire.

6.Watch for the smoke ……, which means the gases have been burned out. Pull the rods out to drop the retort into the burned wood and ashes, stopping the flow of air to the charcoal inside.

7.Wait an hour, then lift the retort out of the drums. Wear welder's gloves, as the retort may not be cool enough to handle. Place the retort in dirt and allow it to cool further.

8.After about two more hours, check to see if the retort is cool enough to touch. If so, remove the lid to check the results of your burn. If successful, the hardwood chunks inside should have reduced by about a third, and been converted to lump charcoal.

Technical parameters of carbonization stove

Type	Model	Capacity	Size	Temperature
Air Flow	3.5 tons	500 kg	4000 × 1500 × 2000 mm	500
	4.5 tons	1000 kg	5000 × 1600 × 2200 mm	500
Spontaneous	3 m ³	1000 kg	2300 × 1600 × 2000 mm	450
	5 m ³	1300 kg	2500 × 1800 × 2000 mm	450
	8 m ³	1500 kg	3500 × 2000 × 2000 mm	480
	10 m ³	2000 kg	4100 × 2000 × 2000 mm	550

Final products

If you want to know more details of our carbonization stove, welcome to contact me!

Contact person:May Jiang

Skype:bojlantian

QQ:1755421435

Mob:0086-15038021962