M-2 Metallographic Sample Polishing machine/Metallographic Specimen Polishing Machine

P-2 Metallographic Sample Polishing Machine

metallographic sample polishing machine (the following is referred as polishing machine) is applied to the polishing for the grinded metal material; it can get a bright metal surface, for observation under the microscope and determination of microstructure.

Structural features outlined:
Polishing Machine is made of welding holder, the table top, polishing plate, polishing fabric, polishing cover and switch boxes and other basic components. Two polishing plates are installed under the work top which is available for the operation of two people at the same time, it is very convenient. Two electric motors are placed under the work-table, connected with surface by fixed-film. The fixed polishing plate’ cone axis is connected with the motor through Spiral shell needle. Polishing fabric are fastened on the throwing plate through the ferrule, the starting and ending of the motor are controlled by the Switch installed in the switch box from the opening up control, after the starting of the motor, we can exert pressure on the specimen by hand, carry out the polishing on the rotating polishing plate .The added polishing liquid in polishing process of polishing liquid can drain through the plastic disk add fixed at the table. Polished covers and covered can prevent dust and other debris fall on the machine in the process of stopping of it, so it will not influence the results of using.

Technical parameters

Desktop double disk metallographic sample polishing machine

P-2T(220v),P-2T(380v)

The machine for double disk desktop polishing machine, for two people at the same time operating, the machine steady running, low noise, use the machine for sample polishing bright as a mirror surface can be obtained, for under the microscope and metallographic organization.

Technology parameters:

motor power: 180 w

Polishing disk diameter: 200 mm

cooling system

speed: 1400 r/min and 900 r/min (custom)

power: 380 v, 50 hz or 220 v, 50 hz (custom)

appearance size: 730 x405x308mm

main accessories: 2 slices polishing cloth

Single plate desktop metallographic sample polishing machine P-1(220v),P-1(380v)

In the process of metallographic sample preparation, sample polishing is a main working procedure, after finish the sample, after polishing machine polishing, bright as a mirror surface can be obtained, P1 polishing machine is collecting the opinions and requirements of various users, it has a smooth transmission, low noise, convenient operation and maintenance, the machine polishing disk diameter and power were greater than the domestic similar products, will be more suitable for the material of the polishing requirement, and is equipped with polishing device is an excellent sample polishing equipment with water.

Technology parameters:

Polishing disk diameter: 220 mm

Transfer rate: 900 r/min and 1400 r/min (custom)

Electric machine: YS7116 0.2 kW 380 v, 50 hz