Leadshine Microstep Driver M860 laser cutting machine driver

leadshine MA860H stepper drive, 1.High performance, cost-effective, 2.Supply voltage up to +72VDC/72V AC - details see: https://www.machineto.com/leadshine-microstep-driver-m860-laser-cutting-machine-driver-10234655

Place of Origin:CN,Guangdong	Brand Name:Leadshine	Model Number:M860	name:Leadshine
Supply voltage:up to +72VDC	Output current:up to 7.2A	GND:Power Ground	A+, A-:Motor Phase A
B+, B-:Motor Phase B

Leadshine Microstep Driver M860 laser cutting machine driver

contact supplier for Leadshine Microstep Driver M860 laser cutting machine driver

leadshine M860 stepper drive
1.High performance, cost-effective
2.Supply voltage up to +72VDC
3.Output current up to 7.2A

leadshine M860 stepper drive

Features

High performance, cost-effective
Supply voltage up to +72VDC
Output current up to 7.2A
Self-adjustment technology
Pure-sinusoidal current control technology
Pulse input frequency up to 300 KHz
TTL compatible and optically isolated input
Automatic idle-current reduction
16 selectable resolutions in decimal and binary, up to 51,200 steps/rev
Suitable for 2-phase and 4-phase motors
Support PUL/DIR and CW/CCW modes
Short-voltage, over-voltage, over-current and short-circuit protection

Introduction

The M860 is a high performance microstepping Drive based on pure-sinusoidal current control technology. Owing to the above technology and the self-adjustment technology (self-adjust current control parameters) according to different motors, the driven motors can run with smaller noise, lower heating, smoother movement and have better performances at higher speed than most of the Drives in the markets. It is suitable for driving 2-phase and 4-phase hybrid stepping motors.

Specifications

Parameters	M860
Parameters	Min	Typical	Max	Unit
Output current	1.8	-	7.2 (5.1 RMS)	A
Supply voltage	+24	+68	+80	VDC
Logic signal current	7	10	16	mA
Pulse input frequency	0	-	300	KHz
Isolation resistance	500			MΩ