Home  >  Industrial Supplies  >  Machine Oil Purifier

1.high quality oil recycling machine, 2.with ISO9001-2008&CE, 3.high oil yield rate, 4.environmental protection - details see: https://www.machineto.com/jl-1-batch-model-waste-oil-recycling-machine-with-cap-6-mt-d-10231677

Brief introduction

High efficiency, energy saving, big handling capacity, convenient installation, environment protection

Get more profits from waste plastic refining

The traditional refinery equipment named earth burner in China now adopts horizontal fixed treater. The technological process is as below: first manually feed the waste engine oil and raw oil extracted from waste plastics and scrap rubber from the top of split treater, then seal up the feed inlet and heat up slowly the bottom of treater with coal of fuel; the volume of a split treater usually is 20 stere, plus15 tons of material, and usually the smelting completes in two weeks. After the smelting is over, stop for 12 hours to make the treater fully cool down, then open the dregs outlet at the bottom of treater to discharge dregs, feed material from the feed inlet of treater to continue another cycle of refining.

the processing flow of Waste oil recycling machine

the processing 3D DRAWING of Waste oil recycling machine

Applicable Products & Industries of Oil Refining Treater

1. Raw oil extracted from waste plastics and scrap rubber

2. Waste engine oil

3. Waste raw oil

4. Waste washing oil

Technological Process

Pump the raw oil for further processing into reboiler, catalyst and heat in a decompression state to distillate oil vapour, make the oil vapour pass the condenser, then the part that can be liquefied will be condensed into oil product, and the part that cannot be liquefied will be sent into air heater for burning.

Analysis of Economic Benefit

1. Technical parameter of equipment

the runing project :

The certificate of oil distillation machine:

Pump the raw oil for further processing into reboiler, catalyse and heat in a decompression state to distillate oil vapour, make the oil vapour pass the condenser, then the part that can be liquefied will be condensed into oil product, and the part that cannot be liquefied will be sent into air heater for burning.The design of unit is reasonable and advanced and the complete set of unit produces no smoke.

1. Technical parameter of equipment

	Serial No.				Contents
1		Equipment type		ZL-1 type		ZL-2 type	ZL-3
2		Raw material		Raw oil Waste engine oil Waste plastic oil Waste rubber oil		Raw oil Waste engine oil Waste plastic oil Waste rubber oil	Raw oil Waste engine oil Waste plastic oil Waste rubber oil
3		Structural form		Vertical band tower		Vertical band tower	Horizontal band tower
4		24-hour disposal amount (no less than)		6 tons raw material		10 tons raw material	25 tons raw material
5		Working form		Intermittent operation		Intermittent operation	intermittent operation
6		Operating pressure		Normal/ Negative pressure		Normal /Negative pressure	normal pressure
7		Oil yield (No less than)		70%-80%		70%-80%	70%-80%