Home  >  Metal Processing Machinery  >  Machine Tool Equipment  >  Welding Equipment  >  Other Welding Equipment

1. PLC touch screen digital control, 2.Resonance:Series resonance, 3.Air cooled, 4.cost-effective, 5.6 channel Temperature - details see: https://www.machineto.com/induction-preheating-machine-80kw-10137911

induction preheating machine 80KW

Our Advantages

1.Versatile Mobility:optional running gear designed for construction and maintenance
2.On-board temperature control:provide for manual or temperature based programming in a simple-to-learn operator interface
3.Muitiple control thermocouple inputs:available to control on the hottest TC during heating and coolest TC during cooling for 4.uniform heating and quanlity
5.Open output detection:prevents system operation without a covered output receptacle(cable or protective plug)
6.Isolation fault protection:provides automatic system shut down power source output to ground.
7.Low consumable costs:No fuel costs and minimal insulation costs.insulation is resuable and may be used 50 time or more,reducing costs of disposal and replacement.
8.Uniform heating:maintained along and through the heat zone by using induction to heat within the material.the surface of the part is nor marred by localized conducted heat at higher than specified temperatutes.
9.Time-to-temperature:faster than conventional processes due to methed of applying the heat,reducing the heating heating recyle time.
10.Improved working environment: With welding,welders are not exposed to open flame,explosive gases and hot elements associated with fuel gas heating and resistance heating.
11.High energy-efficeent systems:(more than 90 percent efficient)transfers more energy to the part,decreassing heating times and impoving power efficietnt.
12.Easy Set-up:achieved using preheat blankets or flexible heating cables combined with user-friendly insulation blankets.

Specification

1.Process:induction heating machine
2.Maximum Rated output:80KW
3.Input Power:380V 3-Phase,50HZ
4.Rated Output:80KW at 100% duty cycle,1-35KHZ
5.Input Amperes at Rated Output:380V:122A
6.Dimensions:H:880MM W:663MM D:982MM
7.Weight:201KG

Feature
1. Air cooling:Not water cooling, Convenience to install
2.Temperature recorder: Record the whole heating curve
3.Flexible induction coil: Easy to wind on different working piece
4.Temperature Controller: Keep the heating process same with PWHT requirement

5.PLC touching screen: Intuitive to see and easy to operate
6.Induction heating power: High heating speed and heating efficiency, energy Saving

Application

With the induction annealing machine , this simple and cost-effective heating process can be applied in the following applications to deliver fast and consistent heat:

• Welding fabrication and construction;
• Preheating of welds;
• Post-weld heat treatment;
• Coating removal;
• Shrink Fit and so on

• Application: Pre-heating of a valve body to 400°F before welding on a repair.

  Application: Post Weld Heat Treating (PWHT) a P91 header to 1400°F after welding

  Application: Post Weld Heat Treating (PWHT) a carbon steel pipe to 1250°F after welding.

  Application: Pre-heating two joints to 300°F before welding, with a single coil.

  Application: Pre-heating of structural steel tube to 300°F.

  Pre-heating of an in-service pipeline to 100°C before welding on a sleeve.