Home  >  Metal Processing Machinery  >  Metal & Metallurgy Machinery  >  Metal Casting Machinery

1.EMS inside mould using mould water., 2.EMS inside mould using clean water., 3.EMS outside mould., 4.Inner cooling type ems. - details see: https://www.machineto.com/high-quality-electromagnetic-stirring-system-ems-for-bloom-with-ce-certified-10160889

Electromagnetic Stirring

Technical Features of SWDCT EMS

1.A new algorithm has been developed by "SWDCT" and GL Electromagnetic Field Software Co., names AGILD EM STIRRING ALGORITHM which uses New Strip Magnetic Field Differential Integral Equation.

2.This software can design electromagnetic parameters optimized. EMS shall be with high magnetic induction and stirring force. So stirring effect shall be great.

3.Stirring force can be calculated by this software according different freq and current. So the best freq and current can be provided for user.

4.Optimized design shall be done for L/D. Iron Core length shall be increased properly. So stirring effect shall be improved.

5.Our Term has also other software for designing F-EMS to calculate best position of F-EMS

6.SWDCT uses low voltage and large current, which can avoid damage of peak voltage to insulation. It shall make reduce current leakage and prolong EMS life.

7.Freq arrange shall be widened to choose the best freq.

8.Put EMS lower properly to make magnetic field around meniscus as little as possible to ensure strong magnetic field.

EMS For Bloom(Round)

There are three kinds of EMS according to installation position

--Mould Electromagnetic Stirrer : M-EMS
--Strand Electromagnetic Stirrer: S-EMS
--Final Electromagnetic Stirrer: F-EMS

Features of EMS for Bloom (Round)

1.Mould EMS (M-EMS)

a. EMS inside mould using mould water: EMS is installed inside the mould and uses cooling water system of the mould. It can be operated conveniently with low cost. Stirring freq: 2-8Hz.(Refer to Fig.1).

b. EMS inside mould using clean water: EMS is installed inside water jacket of the mould and uses a separate cooling water system. Structure is compact and life is long. Stirring freq: 2-8Hz.(Refer to Fig.2).

c. EMS outside mould: EMS is installed outside the mould with separate cooling water system. It is simple to change copper tube. EMS can be used for wide range of sections. Stirring freq: 2 ~ 5Hz.(Refer to Fig.3)

d. inner cooling type ems:can be installed inside or out the mould.cramer windings are adopted,which has even magnetic field without polarization.But magnetic leakage is too much with electromagnetic pollution cooling water quality has to be very strict and operation cost is higher.Stirring freq is 1~6Hz.

2.Final EMS (F-EMS)

F-EMS uses rotate field with long iron core. Central magnetic induction is strong and application range is wide. Stirring effect shall be ensured with alternating or intermittent stirring.

\

Technical Table