Home  >  Industrial Supplies  >  Refrigeration & Heat Exchange Equipment  >  Heat Exchanger

1.High efficiency finned tube,3.7 times than smooth tube, 2.Small flow rate, big temp. difference, 3.Best choice for heat pump. - details see: https://www.machineto.com/high-efficiency-tube-in-shell-heat-exchanger-gah06-cmf-for-heat-mode-10241982

Work Condition:
1)Refrigerant side (Between the tube and shell):R22,R134a,R404a,R407c,R410a,R600a,etc.

2)Water side (inside of the tube):Domestic water,tap water,antifreeze (glycol solution)

3)This structure A suitable for used ascondenser,For heat mode.

Material:
1)Heat transfer Tube:High efficiencyfinned copper tube,(Optional: finned nickel-copper tube or finned double-wall copper tube)

2)shell:High quality steel ,thickness:4mm.

Features:
1)Thanks to thesmall flow rate, big temperature difference design,easy to get the high-efficiency heat transfer ability.

2)Small volume Compactly designis helpful to save the space ,Thereby reducing the size of whole units.
3)It's widely used in air-source heat pump, and water-source heat pump.

High Effciency of Heat Exchange:
1)Use efficiency finned copper tube,heat exchange area is 3.7 times than the Smooth Tube,it is a important cause of high efficiency.
2)Inside the tube is screw thread,so the water will eddy flow forward ,it's another cause of high efficiency.
3)The compact helix structure of the coil ensures sufficient heat exchange between the gas and water.

Safety:
1)Whole tube inside shell has no internal joint,that means no welding bug.
2)The Copper Tube is fully shaped and then installed into the shell thus free from Products processing defects.

3)There is no block on water loop and the water flow is smooth,thus keep it avoid dirty.
4)The water pipe is on the lowest position ,and easy for drainage in cold season,avoid freeze.

Structure and Specification

Please check out the detail parameter from the following list.---Model: GAH06-CMF