Home  >  Wood Working Machinery  >  Woodworking Machinery  >  Carbonization Stove

wood charcoal carbonization furnace, 1.save energy, 2.large capacity, 3,no smoke - details see: https://www.machineto.com/high-efficency-new-type-wood-charcoal-carbonization-furnace-10340958

High efficency! wood charcoal carbonization furnace

Character:

This wood charcoal carbonization furnace is ideal equipment to for mass charcoal production. This type of wood charcoal carbonization furnace adopts the structure of unique air storage chamber, to fully reuse the smoke produced during the process of carbonization. 60% of the redundant smoke can be used in drying and carbonization which saves energy and increases the enterprise revenue.

Detailed parameters:

Model	Weight(kg)	Capacity(kg)	Carbonization time(h)	Dimension
SL-300D	2500	300	2--4	3.5*1.5*2m
SL -600D	4000	600	4--6	4*1.5*2m
SL -1000D	5000	1000-1200	6—12	5*1.6*2.2m

Advantages:

1

There have 4 of steel drums at the top of the machine body. Under each drum, it’s a small room to make fire.

2

The 4 drum have lids on top, and in the middle of the lids, there also connect with 4 pipes, is used for gases to escape (gases will come out when heating the drum). This pipe is called the "retort." Fill the retort with the chunks of hard wood and place the lid on top.

3

Place wood and start the fire at the bottom of the drums. Place the retort inside the drum, resting it on the fire.

4

Wait for the fire to get really hot

5

Keep an eye on the smoke. You should be burning for about three hours and the smoke should be……, which means that the water, tar and other compounds in the hardwood chunks are being released. Keep the temperature up by occasionally adding wood to fire.

6

Watch for the smoke ……, which means the gases have been burned out. Pull the rods out to drop the retort into the burned wood and ashes, stopping the flow of air to the charcoal inside.

7

Wait an hour, then lift the retort out of the drums. Wear welder's gloves, as the retort may not be cool enough to handle. Place the retort in dirt and allow it to cool further.

8

After about two more hours, check to see if the retort is cool enough to touch. If so, remove the lid to check the results of your burn. If successful, the hardwood chunks inside should have reduced by about a third, and been converted to lump charcoal.

Show pictures:

If you have any question or any doubt,please feel free to contact me.