Fish feed puffed particle machine

Fish feed puffed particle machine is suitable for fish, shrimp, frog, pigs, ducks and other grain expanded feed machine instructions.

One.A particle bulking machine suitable for fish, shrimp, frog, pigs, duck, etc. Use bulking machine production out of the expanded feed, have puffed right soft ripe, high protein, nutrition is complete, the long time floating water, waste not feed. Add trace elements, and promote fish fast-growing fast long.

Two. Will of wheat with, cornmeal, bean cypress, fish meal, etc., and composite material blends, according to the formula to 10-17% per jin jin water, in the blender stir well, about 3-5 minutes, actuate mix machine stirring dragon, the material drainage savings barrel, the savings barrel stirring dragon suction mouth HuaJi peng. Pay attention to control storage VAT switch-off. From small to large.

Three. Diced part, cut grain size from a grain of hole and decide, if you want to PengHua generally 4.5 cm, Confucius open 4-5, to yield high, not PengHua can open 10-15 hole, small motor can be before and after adjustment, knife in the consequent, blanking when had better use first 3-5 jin feed add more water

Four.The first time after finish material, the forepart blanking part apart, tool hook immediately apart puffed head on the nut, and then starting motor in the machine more She feed out, cleaning nut orifice plate.

A breakdown maintenance measures.

1.The body appear in noise, bearing rotten, wear, or lack of oil. Maintenance measures: open big pulley, front discharge part, the spindle hammer out back. According to the original first in good rear bearing, solid rear cover screw, reentry forepart bearing, to replace oil seal, add bedding lubricating oil, don't add oil.

2. Screw (propeller) general can produce one hundred thousand pounds or so, the output will wear down, not puffed. Processing method: change the new screw (propeller) sets than propeller and durable.

3.Generally, the new propeller with old set, a new set of match the old shaft (propeller) three. The hole large, should change don't hole.

4. The other reasons, discharge nut could not dismantle, usable tool hook to set apart, with vice clamp, with oxygen heating apart.

Factory direct sale, welcome order!