Driving Road Marking Machine/Road Marking Machine Price

1.engine:30HP water-cooled electric start three cylinder in-line low noise and environmentally friendly diesel engine, fuel tank capacity is 100L.

2. Heating mode: propane gas infrared heat source, electronic ignition, automatic temperature control, heat conduction oil heating, save gas 30% than traditional heat source heating mode. Heat is more uniform, faster and safer, more environmentally friendly.

3. Marking mode: left (or right) side of the double match or monogamous auxiliary type of the atomizing air spray gun, spray gun can guide rail move left and right sides of arbitrary, system of atomization gas heating oil circulation pump and heat exchanger is beneficial to improve the effect of spraying gun.

4. Glass beads spray seeding system: double match link type 120 l pressure type with the window glass bead storage tank, which can realize continuous jet beads during construction. Left (or right) double side or single side with adjustable pressure, flow rate and spray painting glass bead spray gun, spray bead firmer, more uniform and more economical.

5. Electronic control: set the multifunction interface, when the factory can according to user's country needs to set up all kinds of commonly used construction lines, and can satisfy the user in the process of using the linear and the need of any length adjustment, realize the intelligent control in the process of marking. Continuous line and the bolt as well as between the above two kinds of linear combination can be done in the same program.

6 paint bucket: Dual HTF with Cold Rolled Steel antioxidant heating insulation barrel, enabling uninterrupted during construction work. Heating temperature can be selected according to the user freedom to control the different varieties of paint, built hydraulic agitator blades upright. Single-barrel capacity 600kg (can be increased). Supply marking machine | marking machine | crossed the road car | hot melt marking machine
7 Air compressor: 2.5m3/min screw low noise, low power air compressor, air source of foot pressure steady.

8 warning function: double with flicker frequency can be adjusted freely (or strobe) warning lights. The rear end configuration of an electronic warning arrow (adjusted flashing arrow direction), to improve the security marking operations.

9. Guide bar: pull-out guide rod, up, down, left and right to adjust convenient.
10 pre-marking system: Optional pre-marking system. Marking operation in another line while completing pre-marking operations, greatly improve the efficiency of the marking construction.
11 Dimensions Weight: 9985 * 2470 * 3625 mm 2700kg

12.Note: The machine can also be produced according to user needs for different country, climate and multi-point technical requirements, extrusion, hot melt marking screeding other way, but also while both room temperature or low pressure airless spray air-assisted spray marking functions.

(2) according to user needs matching different brands, different models and different vehicle platforms dead weight.