Cnc Router

1. X, Z axis are all updated with ball screws, including two screw nuts, plane bearing and couplers. All these will provide very high localization accuracy. It has one 23 high speed stepper motor for X, one 34 stepper motor for Z axis.

2. All the stepper mounts, ball screw mounts are made of steel, by wire cut machines. So they have good size precision and best rigidity than other plans which using aluminum mate.

3. The X, Y axis steppers, we made shells to protect them from fritters.

4. Photocouplers are installed in every axis as the limit/origin check switch. They have very good accuracy to set up a machine coordinate system just like real industrial machines.

5. For the NC control system, including CNC interface board, three stepper drivers, provide quite all-around functions such as STEPPER FREE, EMERGENCY STOP, LIMIT/TOOL ADJUST SENSORS, SPINDLE CONTROL, HALF DRIVE CURRENT, OVER-THERMAL PROTECTION, etc. About its performance, it provides subdivisions up to 100, the performance even near to a servo system. We recommend you use the system with upper software such as MACH (we think the best), KCAM4.

6. All exposed wires are covered by plastic corrugated pipes to make the machine looks cool. A switch is set to the position where the Z axis hand wheel has been. You can use it as coolant switch or FREE, or EMERGENCY STOP.

7.the machine is with a encoder . that is good for process the screw thread .