Home  >  Material Handling Equipments & Parts  >  Material Handling Equipment  >  Conveyors

CFL Soldering Repair Line : the line used for repair the PCB after soldering - details see: https://www.machineto.com/cfl-soldering-repair-line-10196697

CFL Soldering Repair Line :

1. General requirement of line

1.1 Line type: PDX type ,long bar style, single belt , opposite seat type.

1.2 Worker’s seats:10*2=20 pieces

1.3 The length of seats: 1000mm. Total length:10m

1.4 Total line width: belt (400mm) Per worktable width:400mm, total:1200mm

1.5. The height of line body: about 2m, The height of worktable surface:720-750 ( adjustable )

1.6. Speed of conveyer: 0.3-3m/min ( adjust frequency)

1.7 Conveyer medium: green color PVC, static avoid belt ( thickness: 2mm )

2. Requirement of structure

1.The total line use 30*40mm rectangle pipe as skeleton, outer shield frame use DQ308 specific aluminum alloy material, install hopper and hanger.

2.The line body is single wing type haulm ,up-shed open type, equipped 2 pieces of 15W energy saving lamp ( adjustable ) installed in the up-shed.

3.Both sides of worktable are layer press plate, put on 3mm green ripple rubber, plastic around the groove.

4.Instrument meter equipped on the conveyer belt in the middle of worker seat, and equipped one lamp holder, one technology drawing.

5.Per worker’s seat equipped one tool box, plate inside, one power box ( two bores, three bores ),lamp holder ,one iron barrel, one fuse holder.)

6.The whole line equipped one set of wind pipe, per worker’s seat install one wind absorb pipe.( the buyer should responsible for the cost of wind pipe except which equipped by the line )

7.The control box is under machine’s head.