Home  >  Industrial Supplies  >  Motors  >  Stepper Motor

stepper driver 5a, low Noise 2-phase stepping Driver,, Input:24--58VDC;output:1.4--5.6A;Microstep:2-128;5--125 - details see: https://www.machineto.com/2-phase-5-6a-58v-stepper-driver-2m656-10239086

stepper driver 5a

Key Features:

• 24 to 58VDC Supply Voltage
• H-Bridge, 2 Phase Bi-polar Micro-stepping Drive
• Suitable for 2-phase, 4, 6 and 8 leads step motors, with Nema size 16 to 34
• Output current selectable from 1.4 ~ 5.6A peak
• Current reduction by 50% automatically, when motor standstill mode is enabled
• Pulse Input frequency up to 200 kHz
• Optically isolated differential TTL inputs for Pulse, Direction and Enable signal inputs
• Selectable resolutions up to 12800 steps
• Over Voltage, Coil to Coil and Coil to Ground short circuit protection.

Introduction

2M656 is a cost effective, high performance bi-polar two phase micro-stepping drive applying pure-sinusoidal current control technique. It is best suited for the applications that desired extreme low noise and heat. It operates well in an environment, where electricity supply experience instability and fluctuation .

The general pseudo-sinusoidal current control technology adopted by majority of the drive produced distorted sine wave, and current ripple, resulting in vibration, noise and motor heating. This results in motor degrading over time, reducing in motor performance and shortens the usage life.

With an automatic optimization speed control technique, the PowerStep series drive output is very stable, with almost zero vibration and noise, performing close to a servo system, allowing the motor to operate smoothly. That helps to fulfill a design requirement of low noise, low heat and high performance.

Cooling	Natural Cooling or Forced Convection
Environment	Space	Avoid dust, oil frost and corrosive gases
	Ambient Temperature	0°C50°C
	Humidity	40 80%RH
	Vibration	5.9m/s² Max
Storage Temp.	-10°C 80°C
Weight	Approx. 260 gram

Microstep Setting

Step / Rev	SW5	SW6	SW7	SW8
200	OFF	OFF	OFF	OFF
400	ON	OFF	OFF	OFF
500	OFF	ON	OFF	OFF
800	ON	ON	OFF	OFF
1000	OFF	OFF	ON	OFF
1250	ON	OFF	ON	OFF
1600	OFF	ON	ON	OFF
2000	ON	ON	ON	OFF
2500	OFF	OFF	OFF	ON
3200	ON	OFF	OFF	ON
4000	OFF	ON	OFF	ON
5000	ON	ON	OFF	ON
6400	OFF	OFF	ON	ON
8000	ON	OFF	ON	ON
10000	OFF	ON	ON	ON
12800	ON	ON	ON	ON

* SW4: ON=Full current, SW4 : OFF=Halfcurrent