1575mm/1760mm 10TPD A3/A4 paper making machine (production line)

Ⅰ.Brief introduction:

1575mm A4 paper machine can use waste paper as material to make high quality A4 paper ,writing paper ,copy paper ,capacity is 10 ton per day ;

This project include following section :

1.pulp making production line;

2.paper making production line;

3.paper processing machine ;

4.boiler section ;

Ⅱ.Technical parameters:

1. Raw material: waste paper ,sugarcane bagasse ;

2.Output paper : A4,A3 paper ,printing paper ,copy paper ;

3. Capacity :8-10 ton per day ;

4. trim paper width: 1575mm (max width can be 1600mm) ;

5.Output paper weight: 45-60g/m2 ;

6.design speed:120m/min ;

7.working speed:60-100m/min ;

8.width of wire : 1950mm ;

9.bearing center-center:2400mm ;

10. Drive way: Alternating current ,frequency conversion, speed control, section drive;

III.Main technical description of paper machine :

1.Fourdrinier section :

The length of fourdrinier part is 8.5m, forming board, scrape water board, stainless steel solder, faceplate macromolecule anti-grinding faceplate. Table roller: Seamless steel board is covered with rubber, Frame: box, macromolecule anti-grinding faceplate. Suction box: is made of stainless steel solder, faceplate box, square frame is made of steel.

2.main press section:

Two sets of press section ,500mm x 1950mm x 2400mm granite roll 2 pc,450mm x 1950mm x 2400mm rubber roll 2pcs,material :cast iron ,coated by rubber ;

3.Felt press section :

450mm x 1950mm x 2400mm rubber roll 2pcs,material :cast iron ,coated by rubber ;

4.vacuum press section :

650mm x 1950mm x 2400mm vacuum press roll 1 set,material : stainless steel ;

5.Dryer part:

1500mm x 1950mm x 2400mm alloy dryer cylinder 6pcs, it is equipped with upper and bottom dry mesh device.

6. calendar section :

1575 mm three roll calendar 1 set ;

7.paper reeling section :

1575 mm reeling machine 1 set ,diameter of reeling cylinder is 900mm ;

IV.Main machine list :

V.perfect service :

1.technology consultation ;

2.project evaluation;

3.detailed design of factory ;

4.installing and testing the whole production line;

5.training engineers and workers;

6.supplying spare part for long time;