Multi lines flavor oil packaging machine

1.Installation

1) Please confirm your factory have enough place size(L*W*H) for complet set of packaging machine.
2)Do not place the packaging machine near flammable gas and in flammable and explosive environment.
3)Before power on, make sure that the power (220V /380V 50Hz/60Hzand the earth wire are ready. The grounding terminal should be connected to the ground permanently.
4)Installation, inspection and repair should be done by qualified technicians.
5)Requirement for the air compressor: 0.6-0.8Pa, 0.3m3 /min.
6)Prepare the material to be packed and the packaging film.

2. Maintenance

1)Quick-wear components replacement
a.If the film-drawing belt slides or is worn, please replace it. After removing the cover, loosen the M12 nut and the M6 screw so that the axis of driven wheel can move down. Then take out the belt, replace it with a new one and tighten the screw. Please be noted that the belt should not be too tight or too loose.
b.Cutter replacement. Loosen two M5 screws, take out the old cutter from the cutter slot and replace it with a new one, then tighten the screws. Please be aware of the hot sealing roller and the marks on the cutter slot ends.
c.Color ribbon replacement. Please take out the color ribbon core from the slot and put in the new color ribbon.
2)Daily maintenance
a.Please let the machine run for a short period without feeding any materials after installation and adjustment, and run for 3-5 minutes without feeding any materials before working each time.
b.Please check the oil in the air-supplying dyad oil tank before you run the machine, and make sure that the oil volume is more than 1/3. If it is less than that, please inject 20# pure machine oil.
c.Please smooth the movable components by putting 20# pure machine oil on them before you run the machine.
d.Please take out the remaining package films when you stop the machine to avoid bending of the package film axis.
e.Keep the photoelectric head clean and prevent the electric components from moisture.
f.If there is any dirt on the sealing roller, please stop the machine immediately and clean the sealing roller with steel brush.
g.Check the screws on each component regularly to avoid loosening. If there is any unusual noise, please stop thepackaging machineimmediately and check it...