Home  >  Mining & Metallurgy Machinery  >  Mining Machinery  >  Mining Feeder

Specifications, 1. Big feeding capacity, 2. Reliable operation and easy maintenance, 3. Less power consumption - details see: https://www.machineto.com/mining-equipment-vibrating-chute-feeder-for-mineral-processing-10316268

Main introduction of chute feeder

Chute feeder is widely used in mining. In the mining line, Chute feeder is generally installed in front of the primary crusher. It can send the big ore to crusher evenly and continuously.

Chute feeder can effectively control the feeding capacity to match with the capacity of the whole crushing plant.

Notes: The motor can be replaced by speed adjustment motor to adjust the feeding capacity according to the customers’ requirements.

Structure and working principles

1,Motor 2,Reducer 3,eccentric mechanism 4,idler 5,chute frame

The devices are installed on the bottom of the ore bin outlet, the ore fall onto the leakage board at the chute bottom, the bottom of the leakage board is fixed on the idler, and through the eccentric institutions to connect the leakage board and the reducer together, and then through the coupling lined the motor. During the operation the motor drive the reducer through the coupling, and through the eccentric dish and the leaking plate, which is at the bottom of the frame also between the idlers, to move in reciprocating linear way, and achieve the feed uniformly.]

Some pictures of chute feeder

Technical parameter

Type		CG-400*400	CG-600*500	CG-1240*980
Outlet (L×W) (mm)		400*400	600×500	1240*980
Capacity t/h		10-30	10-50	39-90
Max feed size (mm)		100	200	250
Motor	Model	Y112M-6	Y112M-4	Y160M-6
	Power	2.2 kw	4kw	7.5 kw

Usage in dressing plant such as gold, iron, copper, etc

Attention:

1. Double-check whether the bolts of the equipment and hopper are fastening or not.

2. Check whether the all the lubrication point is full of lubricating oil.

3. No allowing too much ore on the chute when start the equipment, it can feed ore only after the normal operation of equipment.

4. Adjust the eccentricity of the feeder’s two sides to the same, and the amplitude is no less than 5~5mm.

5. Before stop the equipment first should stop feeding, the electrical motor can be shut down only after all the ore are discharged.