Home  >  Industrial Supplies  >  Industrial Filtration Equipment  >  Dust Collector

A.The dust collector is not suitable for high temperature and corrosive gas purification. The maximum allowable temperature: "In - details see: https://www.machineto.com/mc-ii-pulse-jet-bag-filter-10225970

MC-II Pulse jet bag filter

This company for working condition of the production workshop dust XK series filter, basically have rotary cleaning the flat bag filter, air box pulse bag filter, low pressure injection pulse dust collector, PL stand-alone dust collector, sink flowtype dust collector, cartridge dust collector, welding smoke, dust collector such as a variety of products to meet different places, different environments, different dust collection and processing. Product technical indicators have reached international advanced level, and sales throughout the country, is currently on the market better dust removal equipment.

Working principle:
1.the working principle and technical performance of MC-II Pulse jet bag filter
The dusty gas by the dust collector air inlet into the box in the middle and lower.Through the bag into the upper box, as a variety of roles to dusts, gases separated, dust is adsorbed on the bag on the gas through the filter bag into the box by the venturi pipe from the outlet discharge.The dusty gas through the filter bag purification project, as time increases, while the dust accumulated on the filter bag on more and more, and thus gradually increase the resistance of the filter bag gradually reduce the amount of gas through the filter bag.The dust collector can work properly, so it is a resistance control within the limits (usually 120 --- 150 mm water column). By the control device is necessary so that when the resistance rose to a limited range of time, issued a directive in order to trigger the control valve, opening the pulse valve, the compressed air within the air bag by the injection tube to the aperture venturi jet to the corresponding bag bag airflow instantly reverse the role of rapid expansion, so that the dust accumulated on the surface of the bag off, bag regeneration.As the plot attached to the bag on the dust cleared on a regular basis, and the purified gas through normal, to ensure the normal work of precipitate.

Injection system and its working principle
Termination compressed air injection system and how it works by the pulse valve A packet injection tube, B termination, access control valve pulse valve pressure chamber, the controller controls the control valve and the pulse valve open when the controller signal outputcontrol valve exhaust port closed, the injection port of the pulse valve is turned off, when the control device signal, the control valve exhaust port is opened the gas pulse valve pressure chamber to vent out, the pressure decreases, the diaphragm on both sides of differential pressure,produce a shift in the diaphragm due to pressure difference, the pulse valve injection port open, the compressed air from the air bag sprayed by blowing holes through the pulse valve to the venturi tube into the bag (the exhaust gas from the injection pipe to the primary air)resulting in an instant positive pressure inside the bag to achieve cleaning.Clear dust, the time of each injection of the pulse valve gas known as the pulse duration or pulse width, two adjacent pulse valve injection interval for the pulse interval (also referred to as the injection interval) all the bag to complete a clear gray cycle time of the pulse period (also known as injection interval) to adjust the pulse period and pulse duration of the control device, and allows dust to keep the resistance within the limits.

3.Dust collector performance
A.The dust collector is not suitable for high temperature and corrosive gas purification. The maximum allowable temperature: "Industry 208" polyester flannel filter, the operating temperature should not exceed 120 degrees Celsius; using blankets filter operating temperature shall not exceed 80 degrees Celsius.
B.This filter under pressure for 300 mm jets.