Cathode ray soft hard moderate Mechanical strength China

2013 China Chengyi Cathode ray

The discharge capacity of cathode electrode is good or bad and the corona discharge point (both curvature), when the corona electrode discharge point of dust gather its curvature is smaller, has a great influence on the effect of such discharges it. The corona wire type has a lot of kinds, the discharge point of the more the corona effect is better, but the discharge point more, manufacture and installation of the more difficult. Corona wire is generally connected with high voltage electricity, need to have good insulation device.

Due to the corona line between interval, interval far influence of corona current. The interval is too close, may produce shield phenomenon between corona wires, weakened by the corona wire surface electric field intensity. The upper and lower part of the dust collector are fixed, and the collecting electrode is grounded. General requirements for dust easily settlement on the plates, resulting in vibration when two little dust, but also requires more portable plates, but also have a certain rigidity, vibration when the dust is easy to fall and no deformation.

Transmission line distribution device on the device in the corona wire, the use of electromagnetic and electrostatic corona dust inside the insulation between the drive shaft, bearing, seal with sealing ring pad type, prevent the dust out or leakage into the cold air. On the outside of the transmission shaft are provided with insulator, it is tubbiness a truncated cone shaped, insulator depending on the gravity will wind chamber and the external sealing isolation, there is a big hole in the lower end surface of the insulator, there is a large space between the drive shaft and the dust collecting casing, the danger will not have a short circuit. When the dust reaches a certain thickness, it will influence the efficiency of dust collection electric, especially for the corona pole, so the electric dust on both beating device corresponding to regular dust. The corona polar beating device is on top of the electric dust, it is through the motor drive to a ratchet, ratchet wheel is driven by the rolling hammer. The hammer is fixed on the longitudinal position of different axial, drive shaft, when the process of rolling over, each time only a hammer a row of plate.

Electrostatic precipitator corona wire has high mechanical strength, not easy to break, easy cleaning, corona wire stainless steel with 304 stainless steel sheet is bent, and the vertical and corona wire prick out on both sides of the pressing plate. The corona line can be installed in horizontal or vertical electric dust collector, has good volt-ampere characteristics of adaptability, dust resistivity changes of strong, cut-off voltage than using other corona wire collector has the advantages of high above twenty thousand volts.

Cathode ray type: Star line, imported stainless steel spiral line, cross spur line, V barbed wire needle, spur barbed wire needle, four tooth barbed wire needle, two tooth barbed wire needle, oblique four tooth barbed wire needle, barbed wire connector (hole), barbed wire screw rod joint, barbed wire connector (elliptical hole), spiny zigzag barbed wire barbed wire, barbed wire, V barbed wire .

We also provide the following products: