Home  >  Mining & Metallurgy Machinery  >  Mining Machinery  >  Mining Feeder

1. Easy adjustment, 2. Reliable operation and easy maintenance, 3. Less power consumption, small start-up current, low noise - details see: https://www.machineto.com/before-crusher-evenly-feeding-ore-feeding-machine-oscillating-chute-feeder-10315811

Yantai Jinpeng Mining Machinery CO., LTD

Professional mineral processing design, equipment production,installation and conmissioning institue.

Tel: 0086-535-3975297

Before crusher evenly feeding ore feeding machine oscillating chute feeder

Chute feeder is widely used in mining. In the mining line, Chute feeder is generally installed in front of the primary crusher. It can send the big ore to crusher evenly and continuously.

Chute feeder can effectively control the feeding capacity to match with the capacity of the whole crushing palnt.

Notes: The motor can be replaced by speed adjustment motor to adjust the feeding capacity according to the customers requirments.

The devices are installed on the bottom of the ore bin outlet, the ore fall onto the leakage board at the chute bottom, the bottom of the leakage board is fixed on the idler, and through the eccentric institutions to connect the leakage board and the reducer together, and then through the coupling lined the motor. During the operation the motor drive the reducer through the coupling, and through the eccentric dish and the leaking plate, which is at the bottom of the frame also between the idlers, to move in reciprocating linear way, and achieve the feed uniformly.

1. Easy adjustment

2. Reliable operation and easy maintenance

3. Less power consumption

Outlet (L×W) (mm)		600×500
Capacityt/h		10-50
Max feed size mm		200
Motor	Model	Y112M-4
	Power	4kw

1. Double-check whether the bolts of the equipment and hopper are fastening or not.

2. Check whether the all the lubrication point is full of lubricating oil.

3. No allowing too much ore on the chute when start the equipment, it can feed ore only after the normal operation of equipment.

4. Adjust the eccentricity of the feeder’s two sides to the same, and the amplitude is no less than 5~5mm.

5. Before stop the equipment first should stop feeding, the electrical motor can be shut down only after all the ore are discharged.

Usually used in the following similiar process of gold,silver,copper, lead zinc, molybdenum and so on.

Provide ore dressing experiment,process design and onsite engineering service.

Welcome to visit our lab, design institute and factory!